Anaheim Lake Vertical Turbine Pump and Motor Inspection and Rehabilitation

SCOPE OF WORK 1. The pump and motor are to be pulled and transported by the contractor, using contractor-supplied equipment. OCWD will assist by having the pump flow locked out and the wiring disconnected. The contractor shall remove the roof covering. See Exhibit B for a record drawing and photographs of the existing site. 2. Inspect and rebuild the pump and motor as necessary. Include pricing to remove, pick up, clean, disassemble, inspect and repair pump column pipe, shafting straightness, shafting bowl and impeller assembly, discharge head, and motor (Motor bearings, test, bake and dip). Balance shaft and assembly of pump. 3. Reinstall the rehabilitated pump, motor, and roof covering in the same location including gaskets and packing/mechanical seal, including connection to the discharge pipe. OCWD will land the wiring. 4. Provide commission testing, troubleshooting, and start-up support. Note that this process may not take place until several months have passed after the reinstallation. 5. Provide a written, detailed report with measurements and pictures of conditions found. Provide observations on possible causes of pump and motor wear or potential future mechanical issues.